Jump to content
ELKSLAYER

.223 vs NATO 5.56

Recommended Posts

So there is quite a bit of confusion over whether or not a .223 is actually a 5.56, or can a weapon chambered .223 fire a 5.56. Well here is some info that should help clear things up. A 5.56 chambered weapon can fire a .223 without issue, where a .223 chambered weapon could potentially have negative results firing a 5.56.

While the 5.56mm NATO and .223 Remington cartridges and chamberings are very similar, they are not identical.

Military cases are generally made from thicker brass than commercial cases; this reduces the powder capacity (an important consideration for handloaders), and the NATO specification allows a higher chamber pressure. NATO EPVAT test barrels made for 5.56mm NATO measure chamber pressure at the case mouth, as opposed to the location used by the United States civil standards organization SAAMI. The piezoelectric sensors or transducers NATO and SAAMI use to conduct the actual pressure measurements also differ. This difference in measurement method accounts for upwards of 137.9 megapascals (20,000 psi) difference in pressure measurements. This means the NATO EPVAT maximum service pressure of 430 megapascals (62,000 psi) for 5.56mm NATO, is reduced by SAAMI to 379.21 megapascals (55,000 psi) for .223 Remington. In contrast to SAAMI, the other main civil standards organization C.I.P. defines the maximum service and proof test pressures of the .223 Remington cartridge equal to the 5.56mm NATO.

The 5.56mm NATO chambering, known as a NATO or mil-spec chamber, has a longer leade, which is the distance between the mouth of the cartridge and the point at which the rifling engages the bullet. The .223 Remington chambering, known as SAAMI chamber, is allowed to have a shorter leade, and is only required to be proof tested to the lower SAAMI chamber pressure. To address these issues, various proprietary chambers exist, such as the Wylde chamber (Rock River Arms) or the ArmaLite chamber, which are designed to handle both 5.56mm NATO and .223 Remington equally well. The dimensions and leade of the .223 Remington minimum C.I.P. chamber also differ from the 5.56mm NATO chamber specification.

Using commercial .223 Remington cartridges in a 5.56mm NATO chambered rifle should work reliably, but generally will not be as accurate as when fired from a .223 Remington chambered gun due to the longer leade. Using 5.56mm NATO mil-spec cartridges (such as the M855) in a .223 Remington chambered rifle can lead to excessive wear and stress on the rifle and even be unsafe, and the SAAMI recommends against the practice. Some commercial rifles marked as ".223 Remington" are in fact suited for 5.56mm NATO, such as many commercial AR-15 variants and the Ruger Mini-14, but the manufacturer should always be consulted to verify that this is acceptable before attempting it, and signs of excessive pressure (such as flattening or gas staining of the primers) should be looked for in the initial testing with 5.56mm NATO ammunition.

Additional information at:

.223 Remington - Wikipedia, the free encyclopedia

Share this post


Link to post
Share on other sites

I ended up with a couple hundred pieces of brass of 5.56 and gues I will make sure it doesnt get mixed up all the other stuff I have, so thanks

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Upcoming Events

    No upcoming events found
  • Recently Browsing

    No registered users viewing this page.

×