Jump to content


  • Upcoming Events

    No upcoming events found
  • Recently Browsing

    No registered users viewing this page.

Dangle

Factory Quick connects on fuel lines.

Recommended Posts

Anyone know where to get a set to install a lift pump without cutting any lines?? I would be fine with installing a lift pump as long as i could go back to stock easy if needed.

Share this post


Link to post
Share on other sites

Steve, you can just slide the hose over the barb that the quick connect clips over and put the hose clamp on it so it can't slide back off. I think that's what Rob did with his.

Share this post


Link to post
Share on other sites

Same deal. The way it works is you disconnect at the tank. That line runs down the top of the tank and into a hard line on the frame on the frame rail. Where you disconnect the rubber line that runs across the top of the tank it will leave two identical male fittings. You can mount your pump near the front of your fuel cooler or on the side of your tank and just put it in line with the new hose you run to replace the one you removed.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×