Jump to content

Recommended Posts

Last night on the way home I start detecting a vibration occurring when the driveline went slack. Kind of knew at that point the rear driveshaft was going to be the trouble maker. I found a way to change the rear most u-joint in under 1 hour without pulling the driveshaft. I grabbed the Harbor Freight Ball Joint Press and began to press the old joint out. Finish the job and rolled it out of the shop in under 1 hour.



Share this post

Link to post
Share on other sites

At least I could just use that ball joint press to just press the bearing caps off and change it fast. Much better than pulling the entire driveline and wrestling it in the shop on the floor. Always looking for easier way to do things and this was one of them.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Upcoming Events

    No upcoming events found
  • Recently Browsing

    No registered users viewing this page.